Pi-Star Support

I saw the announcement, but didn't dig into the code.

XLXd with NXDN support on-board, to save you from making this hard...

So your XLX will connect direct to your NXDN reflector

YSF2NXDN does not work for the need that you have right here, it expects YSFGateway or MMDVMHost to connect to the YSF side - this is why its not working for you

I’ve seen it, it’s pretty awesome! It’ll be a huge PR if submitted :)

there are other ways that are cleaner

Good morning! Is it possible to use a 5V relay to activate a cooling fan whenever there is a TX signal, and turn it off again one minute after the TX ends—whether on a hotspot or a repeater?

Might be easier using a thermo switched relay. Something like this… https://www.ebay.co.uk/itm/285811069692?var=0&mkevt=1&mkcid=1&mkrid=710-53481-19255-0&toolid=20006&_ul=GB&campid=5339154538&customid=CjwKCAjwmdLSBhANEiwAkREMNyibhU8vQn2jii_J0shMMfqyQldzEmELuLUDjugPFGuBJwg6lsY3XhoCi7kQAvD_BwE&gbraid=0AAAAA-MzEzdnIZHW2W2sThY_OrGEe5UTL&wbraid=Cj4KCAjw9szSBhBuEi4ADrmHOwB_YMYq-S9uBeoHHe6841cQK-_kCOPmuuqdZHjfBBL6MfdypPy88JZPGgKCYA&gad_source=1&gad_campaignid=23878720043&gclid=CjwKCAjwmdLSBhANEiwAkREMNyibhU8vQn2jii_J0shMMfqyQldzEmELuLUDjugPFGuBJwg6lsY3XhoCi7kQAvD_BwE Though it’s a Pi, with the right script / code you could create something that triggers a pin on its GPIO.

This is exactly the script I need. It would be excellent if this function were built right into Pi-Star. It would allow for temperature control on the hotspot and, especially, on the repeater.

Hi all, Pi-Star:4.1.13 / Dashboard: 20260623 shows timestamps in UTC for my repeaters, but for a local hotspot it shows the local timezone. The timezone is set correctly everywhere. How to fix it? Thanks.

Hi All Is there a solution, how to work with MMDVM and pi-star 4.2.6 with all range user ID? Like as 1,2,10 etc. Local mode I mean. Now I check that, id lower then 10000 does not work.

dmr, dstar, ysf Ham user IDs are 7digit. Only nxdn mode ID's use 5digit.

in the gw the correct master is selected?

Which sequence shall I launch the components?

sorry, it was my first idea...as you know, i m completely out since about six years

try asking here: https://groups.io/g/OpenDV Its the home of the MMDVM sxceiver project.

Hello everyone, I’m running Pi-Star on my MMDVM repeater and once in a while (daily) I can’t seem to activate the repeater via DMR for a while. Anyone experiencing this? If so, has anyone been able to remedy it? Thanks-

Check the logs on pistar it may tell you why